Three-dimensional hot stamping is a composite technology that combines the hot stamping process and the embossing process. It uses the etching or engraving technique to make the graphic that needs hot stamping or embossing to form a female die with a top and bottom fit (ie, a hot stamping plate). And the male mold relief (ie, the bottom mold), thereby achieving the process of hot stamping and embossing once completed.
The production principle of three-dimensional hot stamping and ordinary hot stamping is slightly different, so there are some special points worth noting in the bottom mold installation. The bottom plate of the ordinary hot stamping is flat, and it is only necessary to align the bottom mold with the hot stamping plate and fix it. The bottom die of the three-dimensional hot stamping is a male die letter which is consistent with the hot stamping text and height. It must be completely corresponding to the hot stamping plate when installing, otherwise it will seriously affect the hot pressing effect of the product. The service life of the bottom mold will also be greatly reduced. In the production process, the commonly used three-dimensional hot stamping bottom mold installation method is: after the matching positioning pin is fixed to the hot pressing plate, the air pressure is pressed, and the bottom mold is adhered to the bottom plate through the double-sided adhesive which is pre-applied on the bottom mold. However, this method has the following drawbacks: First, it is inconvenient to replace a single bottom mold in production, second, the accuracy of positioning is not high, and third, it is inconvenient to adjust the position and the pad. In order to overcome these three shortcomings, we can use the method of transparent film proofing to install the counter. The specific method is: according to the size of the hot stamping plate, cut the appropriate area of ​​the transparent film (using the waste film without the graphic part), and fix it on the bottom mold with the transparent tape to press the corresponding place of the graphic, and appropriate Pad up to the appropriate height; then take the aluminum air pressure once, then the anodized aluminum will be printed on the transparent film; then the bottom mold and the transparent film on the graphic part completely overlap, use the transparent tape to fix the bottom end of the bottom mold . With this method, not only is it easy to install the counter, but the pad and fine-tuning work is also very simple.
　　 The above content is selected from the second issue of 2011, Printing and Printing , Packaging and Decoration, and more journal content. Please pay attention to the journal channel.
The serious of ladder tape is used for airtain,we can product these about the width between10mm-40mm.
Ladder Tape
WUXI MIFUN INTERNATIONAL TRADE CO.,LTD , https://www.mifunblinds.com