Cat Alpha Interferon (IFN-α) ELISA Kit Instructions
The company specializes in supplying Elisa kits, quality assurance, price concessions, and can provide free testing services, please call to consult!
This manual is for reference only, subject to the company's current provision, please call to obtain it. This kit can only be used for scientific research, not for medical diagnosis.
Feline interferon (IFN-α) ELISA quantitative detection kit (ELISA)
user's Guide
ã€Cat Interferon (IFN-α) ELISA ELISA Kit Kit Name】
Feline interferon (IFN-α) ELISA quantitative detection kit (ELISA)
ã€Cat Alpha Interferon (IFN-α) ELISA ELISA Kit Kit Uses】
Quantitative detection of serum, plasma and related fluids.
ã€Cat IFN-α (IFN-α) ELISA ELISA kit detection principle】
This kit uses double-antibody two-step sandwich enzyme-linked immunosorbent assay (ELISA). Add the standard and the test sample to the pre-coated cat interferon (IFN-α) ELISA monoclonal antibody transparent enzyme label coated plate. After incubation for a sufficient time, wash to remove unbound components, and then add the enzyme label After incubating the working solution for a sufficient period of time, wash to remove unbound components. Substrates A and B are added in sequence, and the substrate (TMB) is converted into a blue product catalyzed by horseradish peroxidase (HRP), which turns yellow under the action of acid. (IFN-α) ELISA concentration was positively correlated. The OD value was measured at 450 nm wavelength. Based on the OD value of the standard and the sample, the IFN-α ELISA content of the sample was calculated.
ã€Composition of Feline Alpha Interferon (IFN-α) ELISA ELISA Kit Kit】
1
Enzyme coated plate
12 holes × 8
7
Developer A liquid
6mL
2
Standard
0.3mL × 6 tubes
8
Developer B liquid
6mL
3
20 times concentrated washing liquid
25mL
9
Stop solution
6mL
4
Sample diluent
6mL
10
Instructions
1 serving
5
Special diluent
6mL
11
Sealing film
2 sheets
6
Enzyme reagent
6mL
12
sealed bag
1
[Reagents and equipment not required by cat interferon (IFN-α) ELISA ELISA kit]
1. 37 ℃ thermostat
2. Standard specification microplate reader
3. Precision pipettes and disposable tips
4. Distilled water
5. Disposable test tubes
6. Absorbent paper
ã€Cat IFN-α ELISA ELISA kit operating steps】
1. Preparation: Remove the reagent kit from the refrigerator and re-equilibrate at room temperature for 30 minutes.
2. Mixing solution: dilute the 20-fold concentrated washing solution with distilled water to the original one.
3. Add standard products and samples to be tested: take a sufficient number of enzyme-coated plates and fix them to the frame. Set up standard wells, sample wells to be tested and blank control wells, record the positions of each well in the standard wells. Add 50μL of standard product; first add 10μL of sample to be tested, and then add 40μL of sample diluent (that is, the sample is diluted 5 times); blank control well is not added.
4. Incubation: Incubate in a 37 ° C water bath or thermostat for 30 minutes.
5. Wash the plate: discard the liquid, pat dry on the absorbent paper, fill each hole with the washing solution, let stand for 1min, shake off the washing solution, pat dry on the absorbent paper, repeat the washing 4 times (you can also use the washing machine to press Instructions for washing the board).
6. Add enzyme-labeled working solution: add 50μL of enzyme-labeled working solution to each well, without adding blank control wells.
7. Incubation: Incubate in a 37 ° C water bath or thermostat for 30 minutes.
8. Wash the plate: discard the liquid, pat dry on the absorbent paper, fill each hole with washing liquid, let stand for 1min, shake off the washing liquid, pat dry on the absorbent paper, repeat the plate washing 4 times (you can also use the washing machine to press Instructions for washing the board).
9. Color development: add 50μL of developer A solution to each well, and then add 50μL of developer B solution, mix for 30s with a plate mixer (or gently shake for 30s by hand), and avoid color development at 37 ℃ for 15min .
10. Termination: Remove the enzyme labeling plate and add 50μL of stop solution to each well to stop the reaction (the color changes from blue to yellow)
11. Determination: Zero the blank holes, and within 15 minutes after termination, measure the absorbance (OD value) of each well with a wavelength of 450 nm.
12. Calculation: According to the concentration of the standard product and the corresponding OD value, calculate the linear regression equation of the standard curve, and then calculate the corresponding sample concentration on the regression equation according to the OD value of the sample. You can also use various application software to Calculation. The final concentration is the actual measured concentration times the dilution factor.
[Cat IFN-α (IFN-α) ELISA ELISA kit sample requirements]
1. The sample cannot contain sodium azide (NaN3) because sodium azide (NaN3) is an inhibitor of horseradish peroxidase (HRP).
2. The specimen should be extracted as soon as possible after collection. The extraction should be carried out according to relevant literature. If the test cannot be performed immediately, the specimen can be stored at -20 ℃, but repeated freezing and thawing should be avoided.
3. The sample should be fully centrifuged, without hemolysis and particles.
ã€Cautions for Feline Interferon (IFN-α) ELISA ELISA Kit】
1. The experiment is carried out in strict accordance with the instructions, and the result of the experiment must be determined by the reading of the microplate reader.
2. If the enzyme-labeled coated board is not used up after opening, it should be put into a sealed bag and added with desiccant immediately.
3. It is recommended that all standards, samples and blank controls be tested in duplicate, and the average value is taken to reduce the experimental error.
4. Keep in mind that the sample has been diluted 5 times. The calculation result is multiplied by 5 to obtain the actual concentration of the sample.
5. The quantitative range of this kit is 6.25-200ng / L. If it exceeds this range, it is calculated from the extension of the standard curve. It is not used for accurate quantitative results. ), Multiplied by the total dilution factor is the final concentration of the sample.
6. If the color is too light, the substrate incubation time can be extended properly.
7. In order to avoid cross-contamination, the tips, samples and blank controls should be replaced with a new one for each addition; the common components such as enzyme working solution, sample diluent and substrate should be cantilevered, and they should not touch the microwells. ; Do not reuse the sealing film.
8. The kits are used within the warranty period, and different batches of reagents should not be mixed.
9. Substrate B is sensitive to light and avoid prolonged exposure to light.
ã€Summary of the operation procedure of feline interferon (IFN-α) ELISA kit
Prepare reagents, samples and standards
Add prepared samples and standards, and react at 37 ℃ for 30 minutes
Wash the plate 4 times, add the enzyme reagent, and react at 37 ℃ for 30 minutes
Wash the plate 4 times, add color developing solutions A and B, and develop at 37 ℃ for 15 minutes
Add stop solution
Read OD value within 15 minutes
Calculation
ã€Cat IFN-α ELISA ELISA kit detection range】
Please inquire
ã€Cat IFN-α ELISA ELISA Kit Specifications】
96 servings / box 48 servings / box
ã€Storage of Feline Interferon (IFN-α) ELISA ELISA Kit】
Store at 2-8 ℃, protected from light and moisture.
ã€Expiry date of feline interferon (IFN-α) ELISA ELISA kit】
6 months
Product details
About Greener Walker
We are Greener Walker,we tried a variety of ways to protect the environment and finally we find it,the compostable and biodegradable bags.But this way is very very very slow and we just like a walker,but the pollution is a runner.So We need more walkers,we need you!
Love Pets Love Earth
For everyone who loves pets,pets are their family.Therefore,for pets and others,we should minimize the impact on the environment and others when we walking the dog.
Box Contains:
15 Bags/roll and 36 Rolls,totally 540 Bags
Bag's Size:23cm x 33cm(9in x 13in)
NOTICE:
Please store these bags in a cool,dark,dry place and keep them out of sunlight and away from sources of heat or steam.Use all bags within 18 months of purchase,otherwise they will start to degrade over time.
Keep Your Hands Safe:Our poo bags are 100% leak-proof and extra thick,never worry about your hands when you pick the poo up.
Super Value Package:36 rolls and 15 bags per roll,total 540 bags can supply up to 7 months.
About Measures:Bag's size 13x9 inches (LxW),fits all size of dogs and each roll fits standard-size leash dispensers.
Main Material:Unlike other poo bags, ours are made with corn starch blend which more friendly to environment.
Earth Friendly:We use recycled materials in our packaging and roll cores because details matter.
Flat Bags With Epi,Biodegradable Pet Waste Bags,Biodegradable Dog Poop Bags,Biodedradable Doggie Poop Bags
Taizhou Jinchi Sanitary Product Co., Ltd , https://www.jstzjcpetwastebag.com